4 Ways to Jumper the Most Powerful Car Battery

Have you ever had an unpleasant incident with a car date? Like for example a car that can't be started when it's about to start? This may be caused by your car battery that has been torn or even has expired.




The thing that can be done for critical times like this is by way of a car battery jumper. But how?


To be able to do this, you have to make sure that you have a set of jumper cables in your car. The most important thing when you want to jump in a car battery is to find a normal car similar to your car that broke down.


Why should you look for a similar car? This is because usually cars with the same type have the same type of voltage on the battery. Ask the owner for help politely and park the car face to face – in front of your broken down car, 1 meter apart.


You must make preparations before starting, such as positioning the transmission on P and manual transmission. The transmission must be in neutral and don't forget to apply the hand brake or parking brake on both cars.


When going to jumper, you have to turn off all the electricity in the car. Both cars must also turn off and the state of the keys removed. Unplug everything connected to the car, whether connected to the cigarette lighter or cell phone charger. This is because it is feared that damage will occur. Here's how the Car Battery Jumper


1. Open the Car Hood


Open the hood of both cars and look for where the position of the battery is. You have to pay close attention to where the positive and negative poles are on the two poles.


Usually these two poles are marked with the symbol + or -. If the terminals of the battery poles are dirty, clean them first with a cloth.


2. Car Battery Jumper Process


After you find the position of the battery along with the location of the positive and negative poles, then you can start doing car battery jumpers. Take a look at the following installation sequence.


First, clamp the end of the red or positive cable clamp on the positive pole of the broken battery. After that clamp the other end of the clamp on the positive pole on the car whose battery is working. Make sure they are tightly clamped and do not come off easily.


Next do it on the black or negative wire, attach it to the negative pole on the working I. Then the other end of the clamp on the body, chassis, or on other metal parts that are on the car broke down.


Note that it should not be connected to the clamping end of the black wire on a dead battery as this can be dangerous. Usually people use this because it is considered that the stun flow will be maximized if the car engine is alive. In fact, it is a battery that can emit gas that is very easy to burn when exposed to fire.


3. Wait


Wait for 1 minute or more, depending on how long the battery has been soaked. You may need to leave the engine running for a few minutes to recharge your soaking battery. Leave the cable attached to both cars even when both cars are on.


If the engine is still difficult to start, even if there is no reaction at all, try letting it sit for a while so that the battery charging process is maximized.


4. Remove the Jumper Cable


If the battery has been successfully turned on, you can remove the attached jumper cable. Pay attention to the following sequence!


Start from the end of the black or negative cable clamp on the car whose battery is the problem, then remove the other negative end of the cable. Then just lepad the positive cable in the same way as the negative cable.


Well, that's a guide on how to jumper a car battery, hopefully you can be helped by the information we have conveyed. Thank you!